Cisco AS5350XM Configuration Manual page 193

The virtual terminal password is used to protect
access to the router over a network interface.
Enter the virtual terminal password, which is used for remote console access.
Step 8
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 9
Configure SNMP Network Management? [no]: yes
Community string [public]:
Configure IP? [no]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure bridging? [no]:
Note If you answer no to IGRP, you are prompted to configure RIP.
Step 10 Enter the letter corresponding to the ISDN switch type that matches your telco switch type, or press
Enter to accept the default.
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [b]:
Step 11 Enter yes to allow users to dial in using ISDN or analog modems.
Do you intend to allow users to dial in? [yes]: yes
There are 16 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller CT1 0,1,...etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Where as CAS configuration
will be configured individually for each controller.
Enter the number of controllers you will be using for the PRI configuration, or press Enter to configure
Step 12
all controllers.
Enter # of controllers, you will be using for PRI configuration [16]:
Configuring controller parameters:
Press Enter for every slot, port, and channel.
Step 13
Configuring controller T1 1/0:
Configuring PRI on this controller.
Configuring controller T1 1/1:
Configuring PRI on this controller.
in software corresponds to Port 0,1,..etc
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Getting Started
9