Cisco AS5350XM Configuration Manual page 89

Basic Configuration Using the Command-Line Interface
If you are having trouble, make sure you turned on the protocols for connecting to the lines (transport
input all) and configured the lines for incoming and outgoing calls (modem inout).
Configuring the Voice Feature Card
A voice feature card with one to six PVDM2-64 modules supports different port densities depending on
codec complexity.
For detailed information about the voice feature card CLI commands, see the
Note
Feature Card for Cisco AS5350XM and AS5400XM Universal Gateways
the following URL:
http://www.cisco.com/en/US/products/ps6706/products_feature_guide09186a008060df15.html
Configure
The voice feature card should work without specific modifications to the software configuration on these
platforms. However, you might need to upgrade the firmware on the voice feature card, depending on
the software release you are using.
To upgrade the firmware of the voice feature card, follow these steps:
Command or Action
Step 1
AS5400> enable
Password: password
AS5400#
Step 2
AS5400# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Step 3
AS5400(config)# voice dsp slot [/dsp] [slot
[/dsp]]
Step 4
AS5400(config-voice-dsp)# firmware location
flash:filename
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Configuring the Voice Feature Card
High-Density Packet Voice
document, available online at
Purpose
Enters the enable command. Enters your
password. You are in privileged EXEC mode when
the prompt changes to
AS5350#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
Enters voice dsp config mode and specifies the
slot/dsp location or a range of slots/dsps.
• For the slot argument, specify a value from 1
to 7 to specify the location of the VFC.
For the dsp argument, specify a value from 1
•
to 24 to specify the location of the DSP.
To specify a range, the first two arguments
•
specify the first slot/dsp in the range. The
second two arguments specify the last slot/dsp
in the range.
Where slash marks appear in the command
•
syntax, they are required.
Specifies that the firmware is in flash memory and
identifies the file name.
or .
AS5400#
or .
AS5400(config)#
29