Cisco AS5350XM Configuration Manual page 81

Basic Configuration Using the Command-Line Interface
Configure the trunk group label.
Step 2
AS5400(config)# interface Serial3:23
AS5400(config-if)# no ip address
AS5400(config-if)# trunk-group PRI-TRUNK-GROUP
Note
Configure timeslots and preference.
Step 3
AS5400(config)# controller T1 3
AS5400(config-controller)# framing esf
AS5400(config-controller)# clock source line secondary 3
AS5400(config-controller)# linecode b8zs
AS5400(config-controller)# pri-group timeslots 1-24
AS5400(config-controller)# trunk-group PRI-TRUNK-GROUP-1
AS5400(config-controller)# trunk-group PRI-TRUNK-GROUP-2
AS5400(config-controller)# trunk-group PRI-TRUNK-GROUP-3
Note
Verify
Use the show trunk group command to display the DS0 lines that belong to a particular trunk group.
A trunk group can be a group of DS0 lines from various signaling channels.
AS5400#show trunk group pri-tg
Trunk group: pri-tg
The timeslots option is not available in the serial interface configuration mode, because a serial
interface may represent an NFAS serial interface.
When a PRI or NFAS trunk is fractionally added to a trunk group, the timeslots keyword is
compulsory.
Description:
trunk group label: pri-tg
Translation profile (Incoming):
Translation profile (Outgoing):
Hunt Scheme is least-used
Max Calls (Incoming):
Max Calls (Outgoing):
Retries: 0
Trunk 2/1:23 Preference 10
Channels : 1-23
Total channels available : 23
Data = 0, Voice = 0, Modem = 0, Pending = 0, Free = 23
Total calls for trunk group: Data = 0, Voice = 0, Modem = 0
advertise_flag 0x00000040, capacity timer 25 sec tripl_config_mask 0x00000000
AC_curr 24, FD_curr 0, SD_curr 0
succ_curr 0 tot_curr 0
succ_report 0 tot_report 0
changed 0 replacement position 0
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
NOT-SET (Any) NOT-SET (Voice) NOT-SET (Data)
NOT-SET (Any) NOT-SET (Voice) NOT-SET (Data)
Pend = 0, Free = 23
Configuring DS0 Trunk Group Dial Out
timeslots 1-10
timeslots 11-15
timeslots 20-22 preference 10
21