Cisco AS5350XM Configuration Manual page 198

Save the Configuration File
Configuring controller parameters:
Press Enter for every slot, port, and channel.
Step 13
Configuring controller E1 1/0:
Configuring PRI on this controller.
Configuring controller E1 1/1:
Configuring PRI on this controller.
.
.
.
.
Configuring controller E1 2/6:
Configuring PRI on this controller.
Configuring controller E1 2/7:
Configuring PRI on this controller.
Enter yes to configure the GigabitEthernet0/0 interface to connect the gateway to a LAN. Then respond
Step 14
to the remaining questions to configure the Gigabit Ethernet port (you can also press Enter to accept the
default):
Do you want to configure GigabitEthernet0/0
Use the 100 Base-TX (RJ-45) connector? [yes]:
Note
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Repeat
Step 15
Step 16 Configure your serial interfaces by responding to the following prompts:
Do you want to configure Serial0/0
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Repeat
Step 17
After you complete the configuration script, the setup script displays the configuration command script.
Go to the next section,
Step 18
Save the Configuration File
To save the configuration file, follow these steps:
Enter 0, 1, or 2 when the following prompt is displayed:
Step 1
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
14
Full-duplex mode enables simultaneous data transfer between a sending and a receiving station.
Step 14 to configure any other Gigabit Ethernet ports, if necessary.
Assign to which interface [GigabitEthernet0/0]:
Step 16 to configure any other serial interfaces, if necessary.
"Save the Configuration
interface? [yes]: yes
interface? [no]: yes
File."