Cisco AS5350XM Configuration Manual page 84

Configuring the Universal Port and Dial-Only Feature Cards
Timeslot(s) Used:24, Transmitter delay is 0 flags
AS5400#
If you are having trouble:
•
•
Configuring the Universal Port and Dial-Only Feature Cards
The universal port and dial-only feature cards support all modem standards and features. Rather than the
more traditional line-to-modem mapping, lines are mapped to a system processing engine (SPE) that
resides on the universal port and dial-only feature cards. Associated SPE firmware serves a function
similar to modem code on a modem ISDN channel aggregation (MICA) technologies modem.
The dial-only feature card only supports dial services. Dial services include modem calls (all
Note
modulations), ISDN digital calls, V.110 data calls, and V.120 data calls. Modem pass-through calls are
not included in dial services.
One SPE provides services for six ports, with additional ports per SPE. Busyout and shutdown can be
configured at the SPE or port level.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
24
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Make sure the serial interface and protocol are up by entering the show interface serial command.
Check the IP address.
AS5400# show interface serial 1/0:23
Serial1/0:23 is up, line protocol is up (spoofing)
Hardware is DSX1
Internet address is 172.16.254.254/16
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Last input 00:00:07, output never, output hang never
Last clearing of "show interface" counters 00:00:06
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
1 minute input rate 0 bits/sec, 0 packets/sec
1 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:24, Transmitter delay is 0 flags
AS5400#
Basic Configuration Using the Command-Line Interface