Cisco AS5350XM Configuration Manual page 142

Upgrading DSP Firmware
Enter the enable command.
Step 1
AS5400> enable
Enter your password.
Step 2
Password: password
AS5400#
You are in privileged EXEC mode when the prompt changes to
Display DSP firmware versions to obtain the filename of the firmware on flash memory.
Step 3
The version number and filename may not match until the upgrade is complete.
Note
AS5400# show voice dsp version
IOS-Bundled Default
==========================
system:/bundled_fw_image
On-Flash Dspware-Filename
=========================
No voice dsp in the slot range 1 to 7
Enter global configuration mode by typing the configure terminal command.
Step 4
AS5400# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
AS5400(config)#
You are in global configuration mode when the prompt changes to
AS5400(config)#
Step 5 Enter DSP configuration mode. You can choose to configure a single DSP or range of DSPs by
specifying the first and last DSP in the range.
AS5400(config)# voice dsp slot/dsp
or
AS5400(config)# voice dsp slot/dsp slot/dsp
You are in DSP configuration mode when the prompt changes to
Specify the DSP firmware file in flash memory to use for the selected DSPs. This is the firmware
Step 6
filename that you obtained in Step 3.
AS5400(config-voicedsp)# firmware location vfc-dsp-upw-7.0.1.2.bin
Specify when the DSP firmware upgrade is to occur.
Step 7
AS5400(config-voicedsp)# firmware upgrade busyout | reboot
Type the exit command to exit DSP config mode.
Step 8
AS5400(config-voicedsp)# exit
AS5400(config)#
Press the Enter key to make the changes, and then type Ctrl-Z to return to privileged EXEC mode.
Step 9
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
6
Version
=======
7.0.200x
Version
=======
.
Managing and Troubleshooting the Voice Feature Card
or
AS5350# AS5400#.
Firmware-Type
=============
c5510
Firmware-Type
=============
AS5350(config)#
AS5350(config-voicedsp)#
or
.