Cisco AS5350XM Configuration Manual page 83

Basic Configuration Using the Command-Line Interface
Configure
Command
Step 1
AS5400> enable
Password: password
AS5400#
Step 2
AS5400# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Step 3
AS5400(config)# interface serial 1/0:23
AS5400(config-if)#
Step 4
AS5400(config-if)# ip address
172.16.254.254 255.255.255.0
Step 5
AS5400(config-if)# isdn incoming-voice
modem
Step 6
AS5400(config-if)# exit
Verify
To verify your D channel configuration, enter the show interface serial command and make sure the line
protocol is up and you are using the correct IP interface. Also, make sure that excessive errors are not
being reported.
AS5400# show interface serial 1/0:23
Serial1/0:23 is up, line protocol is up (spoofing)
Hardware is DSX1
Internet address is 172.16.254.254/16
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
Encapsulation PPP, loopback not set
Last input 00:00:03, output never, output hang never
Last clearing of "show interface" counters 00:00:01
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
1 minute input rate 0 bits/sec, 0 packets/sec
1 minute output rate 0 bits/sec, 0 packets/sec
reliability 255/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Configuring the D Channels for ISDN Signaling
Purpose
Enters enable mode. Enters the password. You are
in enable mode when the prompt changes to
or .
AS5350# AS5400#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
AS5400(config)#.
Enters serial interface configuration mode. After
you configure the T1 controller, a corresponding D
channel serial interface is automatically created.
For example, serial interface 1/0:23 is the
D channel for T1 controller 1. You must configure
each serial interface to receive incoming and send
outgoing signaling.
On a channelized E1 PRI line, the serial
Note
interface is 1/0:15.
Assigns an IP address and subnet mask to the
interface.
Configures all incoming voice calls.
This command has two possible keywords:
Note
data and modem. You must use the
modem keyword to enable both modem
and voice calls. The modem keyword
represents bearer capabilities of speech.
Exits interface configuration mode.
or
23