Cisco AS5350XM Configuration Manual page 189

based on your PRI controllers selection. Whereas CAS configuration
will be configured individually for each controller.
Enter the number of controllers you will be using for the PRI configuration, or press Enter to configure
Step 13
all controllers.
Enter # of controllers, you will be using for PRI configuration [28]:
Configuring controller parameters:
Press Enter for every slot, port, and channel.
Step 14
Configuring controller t1 3/0:1
Configuring PRI on this controller.
.
.
.
.
Configuring controller t1 3/0:28
Enter yes to use robbed bit signaling on the controller.
Step 15
Will you be using CT1 (robbed-bit signaling) on this controller? [yes]: yes
Enter your telco framing type.
Step 16
The following framing types are available: esf | sf
Enter the framing type [esf]:
Enter your telco line code type.
Step 17
The following linecode types are available: ami | b8zs
Enter the line code type [b8zs]:
Enter the letter corresponding to the signaling type to support modem pooling over the T1 lines, or press
Step 18
Enter to accept the default.
The following line signaling types are available
[a] e&m-fgb
[b] e&m-fgd
[c] e&m-immediate-start
[d] fgd-eana
[e] fgd-os
[f] fxs-ground-start
[g] fxs-loop-start
[h] none
[i] r1-itu
[j] r1-modified
[k] r1-turkey
[l] sas-ground-start
[m] sas-loop-start
Note Signaling type R1-ITU is not supported on the Cisco AS5400 platform.
Enter the tone signaling type.
Step 19
The following tone signaling types are available:
Enter the tone signal type [dtmf]:
Step 20 Enter yes to configure digital number identification service (DNIS).
Do you want to provision DNIS address information? [yes]: yes
dtmf | mf
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Getting Started
5