Cisco AS5350XM Configuration Manual page 97

Basic Configuration Using the Command-Line Interface
Note
Step 4 Log in to the EXEC session on the gateway (from the client PC):
This is a secured device.
Unauthorized use is prohibited by law.
User Access Verification
Username: Harry
Password:
AS5400>
Identify the line where the call landed. The following example shows that line TTY 216 accepted the
Step 5
call. The call has been up and active for 30 seconds.
AS5400# show caller
Line
con 0
tty 216
AS5400# show caller user Harry
User: Harry, line tty 216, service TTY
Timeouts:
TTY: Line 1/00
DS0: (slot/unit/channel)=2/0/18
Line: Baud rate (TX/RX) is 115200/115200, no parity, 1 stopbits, 8 databits
Status: Ready, Active, No Exit Banner
Capabilities: No Flush-at-Activation, Hardware Flowcontrol In
Modem State: Ready
Note
Test the IP functionality to support shell sessions. From the gateway, use Telnet to access another device
Step 6
in your network.
AS5400# telnet 171.68.186.49
Trying 171.68.186.49 ... Open
access-gw line 2
access-gw telnet smart
Translating "smart"...domain server (171.68.10.70) [OK]
Trying smart.cisco.com (171.68.191.135)... Open
UNIX(r) System V Release 4.0 (smart)
Many modems support the a/ command, which recalls the last at command. The ath command
hangs up a modem call. The atdl command dials the last telephone number.
User
admin
Harry
Active time 00:00:42, Idle time 00:00:19
Absolute
Limits: -
Disconnect in: -
Hardware Flowcontrol Out, Modem Callout, Modem RI is CD
Integrated Modem
The show caller command was added to the Cisco IOS software in Cisco IOS Release 11.3 AA
and Release 12.0 T. If your software release does not support this command, use the show user
command.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Active
Service Time
TTY 00:39:09
TTY 00:00:30
Idle Idle
Session Exec
- 00:10:00
- 00:09:40
Testing Asynchronous Shell Connections
Idle
Time
00:00:00
00:00:07
37