Cisco AS5350XM Configuration Manual page 61

Basic Configuration Using the Command-Line
Interface
The information in this chapter applies to the Cisco AS5350XM and Cisco AS5400XM universal
gateways. After you have verified your basic setup, you are ready to begin performing basic tasks that
prepare your system for data call processing.
This chapter describes how to use the Cisco IOS software command-line interface (CLI) to commission
your Cisco AS5350XM or Cisco AS5400XM universal gateway and includes the following tasks:
Configuring the Hostname, Password, and Time Stamps, page 2
•
Configuring Local AAA Security, page 3
•
Creating a Login Banner, page 5
•
• Configuring Loopback Interfaces, Gigabit Ethernet Interfaces, and IP Route, page 5
• Configuring the Asynchronous Group Interface, page 6
• Configuring T1 and E1 Feature Cards, page 8
Configuring a Channelized T3 Feature Card, page 11
•
Configuring ISDN PRI, page 12
•
Configuring DS0 Trunk Group Dial Out, page 19
•
Configuring the D Channels for ISDN Signaling, page 22
•
Configuring the Universal Port and Dial-Only Feature Cards, page 24
•
Configuring the Voice Feature Card, page 29
•
Configuring Clocking, page 30
•
Enabling IP Basic Setup, page 34
•
Testing Asynchronous Shell Connections, page 35
•
• Verifying the Final Running Configuration, page 38
• Saving Configuration Changes, page 40
• Where to Go Next, page 40
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA