Cisco AS5350XM Configuration Manual page 199

[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
%LINK-3-UPDOWN: Interface Ethernet0, changed state to up
%LINK-3-UPDOWN: Interface Serial0, changed state to down
%LINK-3-UPDOWN: Interface Serial1, changed state to down
<Additional messages omitted.>
When the messages stop appearing on your screen, press Enter to access the following prompt:
Step 2
AS5400>
%AT-6-ONLYROUTER: Ethernet0: AppleTalk port enabled; no neighbors found
Note
Step 3 The
have just completed the basic gateway configuration. However, this is not a complete configuration. At
this point you have two options:
•
•
Where to Go Next
At this point you can go to
manually.
You can also refer to the following documents for more advanced configuration topics:
•
•
•
•
If you see this message, it means that no other routers were found on the network attached to the
port.
or prompt indicates that you are now at the command-line interface (CLI) and you
AS5350> AS5400>
Run the setup script in the System Configuration dialog again and create another configuration.
Enter the following commands to repeat the setup script:
AS5400> enable
Password: password
AS5400# setup
Modify the existing configuration or configure additional features with the CLI as described in the
Dial Solutions Configuration Guide, the Dial Solutions Command Reference Guide, the Cisco IOS
software configuration guide, and command reference publications. See the
Documentation" section on page
Verifying Basic Setup
Cisco IOS software configuration guide
Command reference publications
Dial Solutions Configuration Guide
Dial Solutions Command Reference
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
21.
for step-by-step instructions to configure the gateway
Where to Go Next
"Obtaining
15