Cisco AS5350XM Configuration Manual page 141

Managing and Troubleshooting the Voice Feature Card
•
The copy ios-bundled command is not necessary with the voice feature card. By default, the version of
Note
DSP firmware bundled with the Cisco IOS software release is transferred to all DSPs that are not
specifically configured for a different DSP firmware file.
Displaying DSP Firmware Versions
Use the show voice dsp version command to list the versions of DSP firmware running on the DSPs,
residing in system flash memory, and bundled with Cisco IOS software. This helps you decide whether
you need to change the version running on the DSPs.
The version number displayed may not match the filename for a short period of time while a range of
Note
DSPs is in the process of downloading new firmware. The version number is updated at the beginning
of the upgrade process, whereas the filename is updated upon completion of the process. This is done
intentionally to enable you to recognize the upgrade process from the show voice dsp version output.
AS5400# show voice dsp version
IOS-Bundled Default
==========================
system:/bundled_fw_image
On-Flash Dspware-Filename
=========================
flash:dsp_c5510_flex.rbf
flash:big.rbf
DSP#
5/1
5/2
5/3
5/4
5/5
Using Unbundled DSP Firmware
Use this procedure to configure DSPs to use unbundled DSP firmware. For more information about
unbundled DSP firmware releases for the voice feature card, see the
section on page
Note By default, the version of DSP firmware bundled with the Cisco IOS software release is transferred to
all DSPs that are not specifically configured for a different DSP firmware file. This procedure is only
necessary if you are using DSP firmware that is not bundled with the Cisco IOS software release.
Use the firmware upgrade busyout | reboot command in DSP configuration mode to configure
when the file named in the firmware location command will be loaded to the DSPs. Two methods
of upgrade are available:
Busyout (the default) upgrades when all calls are terminated on an DSP.
–
– Reboot upgrades at the next DSP reset or system reboot.
Type Version
C5510 4.4.5
C5510 7.3.0
C5510 7.3.0
C5510 7.3.0
C5510 7.3.0
8.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Version Firmware-Type
======= =============
7.3.0 c5510
Version Firmware-Type
======= =============
4.4.5 c5510
4.5.985x c5510
Filename
flash:dsp_c5510_flex.rbf
system:/bundled_fw_image
system:/bundled_fw_image
system:/bundled_fw_image
system:/bundled_fw_image
Upgrading DSP Firmware
"Using the AMR-NB Codec"
5