Placing An Ft Group In Service; Modifying An Ft Group - Cisco ACE-4710-K9 Administration Manual

Chapter 7 Configuring Redundant ACE Appliances

Placing an FT Group in Service

Note

Modifying an FT Group

Note
OL-11157-01
Before you place an FT group in service, be sure that you have associated one
context with the FT group and that you have properly configured the two peers.
To place an FT group in service, use the inservice command in FT group
configuration mode. The syntax of this command is:
inservice
For example, to place an FT group in service, enter:
host1/Admin(config-ft-group)# inservice
To take the FT group out of service, enter:
host1/Admin(config-ft-group)# no inservice
If you need to modify an FT group, perform the following steps in FT group
configuration mode:
Remove the FT group from service by using the no inservice command.
1.
Make the necessary modifications to the FT group.
2.
3. Place the FT group back in service by using the inservice command.
You can modify the priority, peer priority, and preempt command values
without taking the FT group out of service.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Configuring Redundancy
7-23