Cisco ACE-4710-K9 Administration Manual page 302

Displaying Redundancy Information
Table 7-4
Field
Maintenance
Mode
FT VLAN
My IP Addr
Peer IP Addr
Query VLAN
Peer Query IP
Addr
Heartbeat
interval
Heartbeat Count
Tx Packets
Tx Bytes
Rx Packets
Rx Bytes
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-50
Field Descriptions for the show ft peer Command Output
(continued)
Description
Current maintenance mode of the peer context in an FT
group. Applications can turn on maintenance mode when
there is an inability to communicate with the peer, license
mismatches, too many application errors, and so on.
Possible states are:
MAINT_MODE_OFF—Maintenance mode is turned
•
off.
MAINT_MODE_PARTIAL— All standby contexts
•
transition to the STANDBY_COLD state. The ACE
enters this mode if configuration synchronization fails.
• MAINT_MODE_FULL—All contexts on the ACE
become nonredundant causing their peer contexts to
become active. The ACE enters this mode just before
you reboot the appliance and is used primarily when you
upgrade the ACE software.
Number of the interface configured as the FT VLAN.
IP address of the local ACE.
IP address of the peer ACE.
Identifier of the interface configured as the query VLAN.
IP address of the query interface used to obtain the state of
the peer's health when the FT VLAN is down.
Time in seconds that the ACE waits between sending
heartbeat packets.
Number of missed heartbeats that an ACE must detect before
declaring the peer down.
Total number of packets that the local ACE sent to the peer.
Total number of bytes that the local ACE sent to the peer.
Total number of packets that the local ACE received from
the peer.
Total number of bytes that the local ACE received from the
peer.
Chapter 7 Configuring Redundant ACE Appliances
OL-11157-01