Cisco ACE-4710-K9 Administration Manual page 181

Chapter 4 Configuring Class Maps and Policy Maps
Create a TCP connection parameter map by entering the following commands:
Step 3
host1/Admin(config)# parameter-map type connection TCP_MAP
host1/Admin(config-parammap-conn)# reserved-bits allow
host1/Admin(config-parammap-conn)# exceed-mss allow
host1/Admin(config-parammap-conn)# nagle
host1/Admin(config-parammap-conn)# set tcp queue-limit 10
host1/Admin(config-parammap-conn)# set tcp syn-retry 3
host1/Admin(config-parammap-conn)# set tcp timeout embryonic 60
host1/Admin(config-parammap-conn)# exit
host1/Admin(config)#
Create a Layer 3 and Layer 4 policy map to activate the traffic classifications
Step 4
outlined in the previous steps by entering the following commands:
host1/Admin(config)# policy-map multi-match L4_SLB_POLICY
host1/Admin(config-pmap)# class L4_SLBVIP_CLASS
host1/Admin(config-pmap-c)# loadbalance policy L7_SLB_POLICY
host1/Admin(config-pmap-c)# loadbalance vip inservice
host1/Admin(config-pmap-c)# connection advanced-options TCP_MAP
host1/Admin(config-pmap-c)# exit
host1/Admin(config-pmap)# exit
host1/Admin(config)#
Apply the completed policies to interface VLAN 10 by entering the following
Step 5
commands:
host1/Admin(config)# interface VLAN 10
host1/Admin(config-if)# service-policy input L4_SLB_POLICY
OL-11157-01
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Class Maps and Policy Map Examples
4-67