Defining A Class Map Description - Cisco ACE-4710-K9 Administration Manual

Chapter 4 Configuring Class Maps and Policy Maps
Configuring Layer 3 and Layer 4 Class Maps
For example, to define the Layer 3 and Layer 4 HTTP_APP_PROTOCOL_
INSPECTION_CLASS class map and specify that all commands in the class map
must be satisfied for the ACE to indicate a match, enter:
host1/Admin(config)# class-map match-all
HTTP_APP_PROTOCOL_INSPECTION_CLASS
host1/Admin(config-cmap)# description HTTP protocol deep inspection of
incoming traffic
host1/Admin(config-cmap)# match port udp eq 53
To remove a Layer 3 and Layer 4 network traffic class map from the ACE, enter:
(config)# no class-map match-all HTTP_APP_PROTOCOL_INSPECTION_CLASS

Defining a Class Map Description

To provide a brief summary about the Layer 3 and Layer 4 class map, use the
description command in class map configuration mode.
The syntax of this command is:
description text
The text argument specifies the description that you want to provide. Enter an
unquoted text string with a maximum of 240 alphanumeric characters.
For example, to specify a description that the class map is to filter network traffic
to the server, enter:
host1/Admin(config)# class-map HTTP_APP_PROTOCOL_INSPECTION_CLASS
host1/Admin(config-cmap)# description HTTP inspection of incoming
traffic
To remove the description from the class map, enter:
host1/Admin(config-cmap)# no description
Cisco 4700 Series Application Control Engine Appliance Administration Guide
4-27
OL-11157-01