Cisco ACE-4710-K9 Administration Manual page 31

Chapter 1 Setting Up the ACE
At the prompt "Would you like to enter the basic configuration dialog? (yes/no):",
Step 4
type yes to continue the setup (or select no to or bypass its operation and directly
access the CLI).
At the prompt "Which port is used to carry Management vlan (1 - 4)? [1]:",
Step 5
specify the Ethernet port that you want to use to access the Device Manager GUI.
Valid entries are 1 through 4. The default is Ethernet port 1. Press Enter.
At the prompt "Configure GigabitEthernet port mode (Access/Trunk) [Trunk]:",
Step 6
identify whether the Ethernet port is to be configured as a VLAN access port or
as a VLAN trunk port. The default is Trunk. Press Enter.
At the prompt "Which vlan is used as Management vlan (2 - 4095)? [10]:", specify
Step 7
the number you want to assign to the VLAN interface. Valid values are from 2 to
4094. The default is VLAN 10. Press Enter.
At the prompt "What is the Management VLAN ip address [192.168.1.10]:",
Step 8
assign an IP address to the management VLAN interface. When you assign an IP
address to a VLAN interface, the ACE automatically makes it a routed mode
interface. Press Enter.
At the prompt "What is the Management VLAN ip netmask [255.255.255.0]:",
Step 9
assign a subnet mask to the management VLAN interface. Press Enter.
At the prompt "Configure the default gateway? (yes/no) [y]:", choose whether to
Step 10
assign an IP address of the gateway router (the next-hop address for this route). If
you specify yes, enter the IP address of default gateway. The gateway address must
be in the same network as specified in the IP address for a VLAN interface. Press
Enter.
Step 11 After you configure the Ethernet port, port mode, and management VLAN, the
setup script automatically applies the appropriate configuration:
The following configuration will be applied:
interface gigabitEthernet 1/1
access-list ALL extended permit ip any any
class-map type management match-any remote_access
OL-11157-01
Using the Setup Script to Enable Connectivity to the Device Manager
switchport trunk allowed vlan 2
no shut
match protocol xml-https any
match protocol icmp any
match protocol telnet any
match protocol ssh any
match protocol http any
match protocol https any
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-5