Cisco ACE-4710-K9 Administration Manual page 78

Configuring Remote Network Management Traffic Services
Defining a Layer 3 and Layer 4 Policy Map Description
Specifying a Layer 3 and Layer 4 Traffic Class With the Traffic Policy
Cisco 4700 Series Application Control Engine Appliance Administration Guide
2-10
To remove a policy map from the ACE, enter:
host1/Admin(config)# no policy-map type management first-match
REMOTE_MGMT_ALLOW_POLICY
To provide a brief summary about the Layer 3 and Layer 4 remote management
policy map, use the description command in policy map configuration mode.
The syntax of this command is as follows:
description text
The text argument specifies the description that you want to provide. Enter an
unquoted text string with a maximum of 240 alphanumeric characters.
For example, to specify a description that the policy map is to allow remote Telnet
access, enter:
host1/Admin(config-pmap-mgmt)# description Allow Telnet access to the
ACE
To remove a description from the policy map, enter:
host1/Admin(config-pmap-mgmt)# no description
To specify a Layer 3 and Layer 4 traffic class created with the class-map
command to associate network traffic with the traffic policy, use the class
command in policy map configuration mode. This command enters the policy map
management class configuration mode.
The syntax of this command is as follows:
class {name1 [insert-before name2] | class-default}
Chapter 2 Enabling Remote Access to the ACE
OL-11157-01