Displaying The Idmap Table - Cisco ACE-4710-K9 Administration Manual

Displaying Redundancy Information

Displaying the IDMAP Table

Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-46
Table 7-2 Field Descriptions for the show ft group Command Output
(continued)
Field Description
Context Name Name of the context associated with the FT group.
Context ID Identifier of the context associated with the FT group.
The IDMAP table contains a list of the local ACE to peer (standby) ACE ID
mappings for each of the seven object types in the ACE. The local ID and the peer
ID for each object type may or may not be the same, but the mappings (local ID
to peer ID) should be the same on both the active ACE and the standby ACE. The
ACE uses these mappings for configuration synchronization and state replication.
To display the IDMAP table, use the show ft idmap command in Exec mode. The
syntax of this command is as follows:
show ft idmap
Table 7-3 lists the IDMAP table object types available in the ACE.
Table 7-3 ACE Object Types in the IDMAP Table
Object Type
0
1
2
3
4
5
6
For example, enter:
host1/Admin# show ft idmap
Chapter 7 Configuring Redundant ACE Appliances
Object Name
REAL ID
RSERVER ID
SERVERFARM ID
POLICY ID
STICKY GROUP ID
IF ID
CONTEXT ID
OL-11157-01