Chapter 1
Setting Up the ACE
Shutting Down the ACE
Shutting Down the ACE
To remove power from the ACE, press the power button found on the front panel.
Configuration changes that are not written to the Flash partition are lost after a
Caution
shutdown. Before you shut down the ACE, enter the copy running-conf
startup-config command in Exec mode to store the current configuration in Flash
memory. If you fail to save your configuration changes, the ACE reverts to its
previous settings upon restart.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-42
OL-11157-01