Cisco ACE-4710-K9 Administration Manual page 57

Chapter 1 Setting Up the ACE
•
•
•
•
For example, to specify the VT200 terminal, set the number of screen lines to 35,
and set the number of characters to 250, enter:
host1/Admin# terminal terminal-type vt200
host1/Admin# terminal length 35
host1/Admin# terminal width 250
For example, to specify a terminal timeout of 600 minutes for the current session,
enter:
host1/Admin# terminal session-timeout 600
To reset a terminal setting to its default value, such as the screen line length, use
the no form of the command:
host1/Admin# terminal no width
OL-11157-01
monitor—Displays syslog output on the terminal for the current terminal and
session. To enable the various levels of syslog messages to the terminal, use
the logging monitor command (see the Cisco 4700 Series Application
Control Engine Appliance System Message Guide for details).
session-timeout minutes—Specifies the inactivity timeout value in minutes
to configure the automatic logout time for the current terminal session on the
ACE. When inactivity exceeds the time limit configured by this command, the
ACE closes the session and exits. The range is from 0 to 525600. The default
is 5 minutes. You can set the terminal session-timeout value to 0 to disable
this feature so that the terminal remains active until you choose to exit the
ACE. The ACE does not save this change in the configuration file.
The login timeout command setting overrides the terminal
Note
session-timeout setting (see the
Timeout" section).
terminal-type text—Specifies the name and type of the terminal used to
access the ACE. If a Telnet or SSH session specifies an unknown terminal
type, the ACE uses the VT100 terminal by default. Specify a text string from
1 to 80 alphanumeric characters.
width characters—Sets the number of characters displayed on the current
terminal screen. This command is specific to only the console port. Telnet and
SSH sessions set the width automatically. Valid entries are from 24 to 512
The default is 80 columns.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Configuring Terminal Settings
"Configuring an ACE Inactivity
.
1-31