Cisco ACE-4710-K9 Administration Manual page 309

Chapter 7 Configuring Redundant ACE Appliances
Table 7-6
Field
My State (Cont.)
My Config Priority Priority configured on the FT group in the local ACE.
My Net Priority
My Preempt
Context Name
Context ID
Track Type
State
Priority
Transitions
Probe Count
Probes Down
OL-11157-01
Field Descriptions for the show ft track Command Output
(continued)
Description
FSM_FT_STATE_STANDBY_HOT—State that
•
indicates that the local standby context has all the state
information it needs to statefully assume the active
state if a switchover occurs.
Priority of the FT group equal to the configured priority
minus the priority of the FT tracking process failures, if
any.
Preemption value of the FT group in the local ACE.
Possible values are Enabled or Disabled.
Name of the context that is associated with the FT group.
Identifier of the context that is associated with the FT
group.
Type of object being tracked. Possible values are
TRACK_HOST or TRACK_INTERFACE.
State of the tracking process. Possible values are
TRACK_UP or TRACK_DOWN.
Priority of the tracking process.
Number of times that the active member of the FT group
switched over to the standby member.
Number of probes associated with a TRACK_HOST
process.
Number of failed probes.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Displaying Redundancy Information
7-57