Cisco ACE-4710-K9 Administration Manual page 60

Configuring Terminal Settings
Configuring Virtual Terminal Line Settings
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-34
Virtual terminal lines allow remote access to the ACE. A virtual terminal line is
not associated with the console port; instead, it is a virtual port that allows you to
access the ACE.
Use the line vty configuration mode command to configure the virtual terminal line
settings. The CLI displays the line configuration mode. Use the session-limit
command to configure the maximum number of terminal sessions per line.
The syntax for this command is as follows:
session-limit number
The number argument configures the maximum number of terminal sessions per line.
The range is from 1 to 251.
For example, to configure a virtual terminal line, enter:
host1/Admin# config
Enter configuration commands, one per line. End with CNTL/Z
host1/Admin(config)#
host1/Admin(config)# line vty
host1/Admin(config-line)# session-limit 23
To disable a setting for the configured virtual terminal line, use the no form of the
command. For example:
host1/Admin(config-line)# no session-limit 23
Use the clear line command in Exec mode to close a specified vty session. The
syntax for this command is as follows:
clear line vty_name
The vty_name argument specifies the name of the VTY session. Enter a maximum
of 64 characters for the name of the virtual terminal.
For example, to close a specified vty session, enter:
host1/Admin# clear line vty vty1
Chapter 1 Setting Up the ACE
OL-11157-01