Adding A Layer 7 Policy Map Description; Including Inline Match Statements In A Layer 7 Policy Map - Cisco ACE-4710-K9 Administration Manual

Chapter 4 Configuring Class Maps and Policy Maps

Adding a Layer 7 Policy Map Description

Including Inline Match Statements in a Layer 7 Policy Map

Note
OL-11157-01
To provide a brief summary about the Layer 7 policy map, use the description
command in policy map configuration mode.
The syntax of this command is:
description text
The text argument specifies the description that you want to provide. Enter an
unquoted text string with a maximum of 240 alphanumeric characters.
For example, to add a description that the policy map is to perform HTTP deep
packet inspection, enter:
host1/Admin(config-pmap-ins-http)# description HTTP protocol deep
inspection of incoming traffic
To remove the description from the policy map, enter:
host1/Admin(config-pmap-ins-http)# no description
To include a single inline match criterion in the policy map without specifying a
traffic class, enter an applicable Layer 7 match command. The inline Layer 7
policy map match commands function similarly to the Layer 7 class map match
commands. This difference is that when you use an inline match command, you
can specify an action for only a single match statement in the Layer 7 policy map.
To specify actions for multiple match statements, use a class map as described in
the "Specifying a Layer 7 Traffic Class with the Traffic Policy"
The syntax for an inline match command is:
match name match_statement [insert-before map_name]
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Configuring a Layer 7 Policy Map
section.
4-53