HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 92

CAUTION!
-
9 2 Upgrading the Firmware
Follow the steps below to install new server firmware:
1. Obtain a copy of the firmware update file from your
HP-authorized dealer or from HP's Electronic Support services.
2. Login to the server using the command:
ftp <IP-address/host-name>
where <IP-address/host-name> is either the IP address or
the host name assigned to the server.
3. You will be prompted for user ID and password. Use the user ID
root, which has the default password pass. (root is the user ID
with the highest priority.)
4. Issue the command bin to change to binary transfer mode.
5. Issue the command:
put <filename> flash
where <filename> is the name of the new server firmware (for
example, hpcd_411.bin).
Be careful not to interrupt the file transfer. If the transfer is
interrupted, the server may become inoperative and must be
returned to HP.
6. Wait for the transfer to complete. This normally takes 1 to
4 minutes. The server will then automatically restart with the
new server firmware.
7. Log out using the command quit, bye, or exit, depending on
your FTP version.
8. Cycle power to the server.
With the new firmware operating, your password for root
reverts to the original setting pass.
Instructions on how to install your server firmware are also
supplied with the firmware update.