HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 33

Disabling Access
for Other
Protocols
Note
TCP/IP and Web
(HTTP) Settings
Server Password
Automatic Time
Synchronization
In the Detailed View (from the Quick Setup page), you can switch
off all access to the server through other protocols for which you do
not set up access restrictions.
Disable Microsoft Windows access by using the Windows (SMB) tab
and disabling the NetBIOS Protocol Bindings for both NetBEUI
and TCP/IP. Disable UNIX by using the UNIX tab and the Enable
NFS setting. Disable NetWare by using the NetWare tab and the
Enable NetWare setting.
Do not disable Web (HTTP) access. Maintain administrative
access to the server through this web interface.
You must restart the server to effect Detailed View settings.
The wizard for TCP/IP (from the Quick Setup page) allows you to
set the correct subnet mask and default router to accompany the
IP address. Clicking the wizard's Finish button causes the server to
restart for the settings to take effect.
You can enable WINS on the Detailed View setup page for TCP/IP,
or in the wizard for TCP/IP.
The Detailed View setup page for Web (HTTP) allows you to disable
all access to the volumes through this web interface—the File View
(see page 3-10).
To protect the system files, it is important that you change the
server password. For example, users are prompted for the server
password when trying to access the Administration and Quick
Setup web pages for the first time during a session. Under the
Administration tab, click the This Server button and with the
server module highlighted, click the Settings button. On the
resulting page, select the General tab. Change and confirm the
password. Click Save. This new password takes effect without
restarting the server.
Setting up the Network Time Protocol
For automatic time synchronization you can use the Network Time
Protocol (NTP, as defined by RFC 1769). Under the Administration
tab, click the This Server button and with the server module
highlighted, click the Settings button. On the resulting page, select
the Date & Time tab. Select Automatically and network Time
Protocol. Then for NTP Server, specify the IP address or Internet
domain name of the time server.
Or you can use NetWare NDS Time Synchronization if your
network runs NetWare (see page 5-18).
Setup for IP Networks and HTTP 3
-
13