HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 111

Replacing the Server Module
1. With the front cover off (see "Opening the Tower" on
page 10-17), slide the server out from the front of the top bay of
the tower—until the power supply, SCSI connector, and
network connectors are visible.
2. Remove the connectors from the server module, being careful to
not bend the ribbon cable or wires very deeply.
3. Return the server module using the warranty procedure
described in appendix B, "Warranty".
4. The replacement server module has a LAN hardware (MAC)
address that is different from the one recorded on the LAN
Address label on the (top of the) tower. It will be labeled on the
bottom of the replacement module.
5. To install the replacement module, you will install a package of
mounting rails with the included instructions, and then reattach
the connectors described above.
6. Replace the front cover by first hooking the flange of the cover into
the bottom of the tower case. Close the cover by pushing it towards
the main body of the tower. Lock the cover using the key. Refer
to the installation instructions in chapter 2 to reinstall the server
on the network. Use the new LAN hardware address when setting
up network access again (chapters 3–6).
Troubleshooting 10
-
19