Getinge MODUEVO Instructions For Use Manual page 76

Operation and use
5
Accessories
Fig. 45: Removing the control device
5.15.13 Attaching the gas cylinder to the gas cylinder holder
Fig. 46: Attaching the gas cylinder to the gas
cylinder holder
76 / 104
2
1
3
4
W !
AR N I NG
Risk of injury!
The gas cylinder may slip or fall when attached to the gas cylinder holder.
When attaching the gas cylinder to the gas cylinder holder, a second person is re-
quired to support the gas cylinder in case it slipes and falls while the other person
is closing the straps.
3
1
2
Removing the control device
1. Hold the control device at the height of the
touchscreen
wards off the holder
charging station.
2. Remove the control device from the char-
ging station
1. Unfold the straps
cylinder against the support plate
cessary, adjust the support plate
cure the gas cylinder and then fix the
straps .
1
2. If the height of the cylinder part (marked H
on the figure) is between 450 mm-720
mm, one gas cylinder support clamp
must be installed close to the top of the H
H
to ensure the fixation of the cylinder. If the
height of the cylinder part (marked H
shown as figure) is over 720 mm (the full
height of the gas cylinder is limited to 1200
mm), then another gas cylinder support
clamp must be added
installed close to the top of the H, another
should be installed between the gas cylin-
der holder and the first clamp
and pull the holder
1 2
of the stationary
3
by pulling up at an angle.
4
and place the gas
1
2
2
. One should be
3
.
3
Moduevo
IFU 009001001 EN 13
up-
. If ne-
to se-
3