Hitachi Mobile Hard Drive Jumper Setting; Teac 24X Max Slim Cd-Rom Drive Switch Settings; Bios Setup Utility; Hitachi Mobile Hard Drive Jumper Settings - NEC POWERMATE 2000 Service And Reference Manual

Hitachi Mobile Hard Drive Jumper Setting

For systems with the Hitachi 6.0-GB or 12.0-GB EIDE mobile hard drive, the
factory settings for the jumper on the interface connector are shown in the
following table. The factory setting is for a single drive installed on the primary
IDE channel as a master device. The 4-pin jumper block is on the right end of
the interface connector on the drive (when looking at the rear of the drive).
Specifications for the hard drive are included in Section 9.
Function
Master Device
Slave Device
Cable Select
(CSEL)

TEAC 24X Max Slim CD-ROM Drive Switch Settings

Switch settings for the TEAC 24X Max Slim CD-ROM drive are shown in the
following table. The factory setting is for the CD-ROM drive installed on the
IDE secondary channel as a master device. Specifications for the CD-ROM
drive are in Section 9.
Drive Setting
CSEL Signal
Master
Slave (factory setting)
Single

BIOS Setup Utility

The Phoenix
configure the main components of the system.
The system ships from the factory with the correct system parameters for the
configuration. Unless optional hardware is added, it's not necessary to run the
BIOS Setup Utility to operate the system. However, the Setup Utility should be
run to set features that customize the system, such as security features.
2-6 System Configuration

Hitachi Mobile Hard Drive Jumper Settings

Jumper Pins Description
Pins A, B, C, Sets hard drive as master device in single drive system.
D not Factory setting: no jumper.
jumpered
Pins A and B Sets device as slave.
jumpered
Pins B and D Not used.
jumpered

TEAC 24X Max Slim CD-ROM Drive Switch Settings

S1 Setting
Off
On
Off
On
®
Technologies Ltd. BIOS Setup Utility program is used to
S2 Setting
On
Off
Off
On