Hitachi Mobile Hard Drive Jumper Setting; Teac Mobile 24X Cd-Rom Drive Jumper Settings; Bios Setup Utility; Hitachi Mobile Hard Drive Jumper Settings - NEC PowerMate 2000 Series Service And Reference Manual

Hitachi Mobile Hard Drive Jumper Setting

For systems with the Hitachi 6.4-MB IDE mobile hard drive, the factory settings
for the jumper on the interface connector are shown in the following table. The
factory setting is for a single drive installed on the primary IDE channel. The
4-pin jumper block is located at the right end of the interface connector on the
drive (when looking at the rear of the drive).
Specifications for the hard drive are included in Section 9.
Function
Master Device
Slave Device
Cable Select
(CSEL)

TEAC Mobile 24X CD-ROM Drive Jumper Settings

Jumper settings for the TEAC 24X CD-ROM drive are shown in the following
table. The factory setting is for a single drive installed on the IDE secondary
channel. Specifications for the CD-ROM drive are included in Section 9.
Jumper
Master Select (MA)
Slave Present (SL)
Cable Select (CS)

BIOS Setup Utility

The Phoenix
configure the main components of the system.
The system ships from the factory with the correct system parameters for the
configuration. Unless optional hardware is added, it's not necessary to run the
BIOS Setup utility to operate the system. However, the Setup utility should be
run to set features that customize the system, such as security features.
2-6 System Configuration

Hitachi Mobile Hard Drive Jumper Settings

Jumper Pins Description
Pins A, B, C, Sets hard drive as master device in single drive system.
D not Factory setting: no jumper.
jumpered
Pins A and B Sets hard drive as slave.
jumpered
Pins B and D Not used.
jumpered

TEAC 24X CD-ROM Drive Jumper Settings

®
Technologies Ltd. BIOS Setup utility program is used to
Jumper Pin Settings
Enabled. Factory setting: jumper over right-most pins
of 6-pin jumper block on back of drive, next to
interface cable connector.
Disabled.
Not used.