Locating The Jumper; System Board Jumper Settings - NEC Direction SP E-Series Reference Manual

2. Click "Properties." The System Properties box appears.
3. Click the Device Manager tab.
4. Double click "Computer." The Computer Properties box appears and
displays the View Resources folder.
The View Resources folder shows the system resources used by your computer.
For example, it shows a list of interrupts and how they are allocated. If an
interrupt is not in the list, it is available.

Locating the Jumper

The following figure shows the jumper location on the system board.
The following table summarizes the system board jumper settings.
Function
Normal Mode
Configure Mode
Recovery Mode
Locating the Jumper

System Board Jumper Settings

Jumper J8E1
1-2
2-3
None
Configuration
Factory setting. Sets the system for
normal operation. The BIOS uses
current configuration information and
passwords for booting.
Allows system configuration. After
POST, Setup runs automatically. The
Maintenance Menu appears for setting
configuration parameters (including
speed and password settings).
Enables BIOS recovery procedures.
BIOS attempts to recover the BIOS
configuration. A recovery diskette is
required (downloadable from the NEC
CSD website).
System Resources C-3