Table of Contents
Advertisement
NEC SNMP Agent Installation
Install the NEC SNMP Agent software on a system with the Windows 98,
Windows 95, or Windows NT operating system as follows.
Note:
LANDesk Client Manager on a computer that is running the
Windows NT operating system.
1. Close all open applications before installing the NEC SNMP Agent.
2. Insert the NEC Select Install CD into the CD-ROM drive. Click
the screen.
3. Click
Start
E:\NECUtil\NEC_SNMP\setup.exe
4. Click
OK
SCSI Drive Limitations
The following procedures and operating limitations apply to systems whose only
hard drive is a SCSI device.
Booting from a CD
In systems with only a SCSI hard drive, it is not possible to boot from an IDE
CD-ROM drive.
Using the NEC Select Install CD with a SCSI Drive
If a situation arises in which a full operating system restore must be performed
using the NEC Select Install CD, first boot the system from the bootable
diskette. (This might be necessary, for example, if the system does not boot
from the hard drive.) The bootable diskette comes with all systems that have a
SCSI hard drive. After the system boots, proceed with the NEC Select Install
procedure.
Do not install both the NEC SNMP Agent and
on the taskbar, point to and click
. Follow the prompts to install the software.
NEC PowerMate 8100 Series Release Notes 13
Run
, and type
where
E:
is the CD-ROM drive.
in
Cancel
Advertisement
Table of Contents
Need help?
Do you have a question about the POWERMATE 8100 - RELEASE NOTES and is the answer not in the manual?
Questions and answers