Automatic Systems TRS373 Technical Manual page 29

p. 29/48
4.4. TURNSTILE ASSEMBLY AND FIXING
An extra person will be needed during the following steps and until the upper housing has been
removed and fixed.
The various steps described below cover the installation of the turnstile on a finished surface
using an installation kit. These steps are similar to when a sealing frame is used.
4.4.1. Fixed panel assembly
Having installed the mounting brackets (C) in each of the two external uprights (A1 & A2) using screws (E) and
washers (D) [ Fig. 16], place the first fixed panel (A) on the corresponding fixing rails (B). [ Fig. 15]
E
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose
other than the use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic
Systems. The document is subject to change without notice.
TRS373-MT-EN-01
To avoid having to start all over again, make sure upright protectors (F) are present at the
points where fixed panels come into contact with the ground. [ Fig. 15]
Do not tighten the fixing screws. Leave the panel loose so that it can still be adjusted when
mounting the upper housing.
D
B
F
A1
C
B
Fig. 15
A
A2
p. 29/48