marposs IWAVE2 Instruction Manual page 76

7.1.1 Error list
In some cases the display might show an error symbol followed by the error code.
WARNING
If the battery of the handle is down, put it in the Stand charger for at
least one hour.
Error code
E001 - E005
E006
E007 - E034
E035 - E040
E041 - E901
E902
E903 - E999
76
/
Cause
Zeroing is performed very
close to the limits of the
working range.
Put the handle in the charger for a complete charging cycle.
Turn off the handle, keep one of the two buttons pressed five
seconds over the Long press (
Reboot as described on paragraph 5.5. If the problem persists
contact Marposs.
- Instruction Manual
Errors
Contact Marposs.
Perform again the zeroing
operation.
Contact Marposs .
Contact Marposs.
Contact Marposs.
Remedy
blue) then perform the