marposs IWAVE2 Instruction Manual page 57

5.3.5.1 Standard Use Modes
 Initial condition:
 Acquisition mode:
 Description:
WARNING
The transmission of the measure to the electronic unit is possible only if
the gauge is within range of the electronic unit where the Dongle is
installed.
If not, the measure is freezed until the connection is re-
established
(*) Note: If a key is pressed before sending to the electronic unit, the freezed
measurement is lost.
Connected measure handle connected to an
electronic unit.
one of the two buttons
Click
( blue) + Click (
Sending the measure to the electronic unit.
Send measure
*
; then the measure is sent to the electronic unit.
Chapter 5  INSTRUCTIONS FOR USE
blue).
57