marposs IWAVE2 Instruction Manual page 58

5.3.5.2 Free Run use modes

Initial condition:

Acquisition mode:

Description:
WARNING
In the "Free Run mode" (continuous measurement) the measurement
is transmitted when the button is pressed.
The correct transmission is shown on the handle display with the check
mark.
5.4 Switching off the
I-Wave2
The handle is provided with a programmable auto shut down feature. Please
I-Wave2
refer to the
To switch off manually the handle, follow the instructions below:

Initial condition:

Action:
 Description:
5.5 Reboot of the
To reboot the handle, put it in "Sleep mode" as described on paragraph 0, wait at least
five seconds, and then place it on the stand charger.
58
/
Connected measure.
one of the two buttons
Click
Sending the measure to the electronic unit.
Send measure
I-Wave2/Wave2
driver Manual for more details on the available option.
Handle switched on.
Long press
It allows to switch off the handle manually.
I-Wave2/Wave2
- Instruction Manual
(
handle
one of the two buttons
handle
blue).
( blue).