marposs IWAVE2 Instruction Manual page 51

5.3.3.2 Sleep mode

Initial condition :

Access mode :

Description:

Alternative access
mode (quick
activation):
Sleep mode ON
WARNING
Please activate the "Sleep mode" before long term storage and before any
shipment.
WARNING
To disable the "Sleep mode" and re-activate the handle, it must be placed
on a powered stand for charging. After that, the handle is active and it can
work as described in Chapter 5.
Handle switched Off
Simultaneous pressure of 2 buttons
then press of only one of the two buttons (
It allows to enable/disable the " Sleep mode". This mode
allows to save and protect the batteries during long storage
and transportation. With the "Sleep mode" activated, the
handle cannot be switched on.
 Status change (On/Off): Click (
 Press only one of the two buttons (
move to the next parameter.
 Long press only one of the two buttons
( blue) to exit the SETUP menu and return to
the start conditions (START).
Long pressure of the 2 buttons (
It allows to activate the "Sleep mode" starting from every
condition of the handle (measuring, switched off, Stand
Alone mode, etc.).
Chapter 5  INSTRUCTIONS FOR USE
.
(
Sleep mode OFF
red) and
blue).
blue).
blue) to
red).
51