Inspecting The Equipment And Reporting Damage - Eaton Powerware 3G System SC200 Installation And Operation Manual

3G-SC200 Data-Voice-Video Power Solutions Installation Guide
Servicing
•
The DC power system contains hazardous voltages and hazardous energy levels. Do not
attempt to disassemble or service the unit if you are not qualified.
EMC Compliance
•
Powerware Data-Voice-Video Power Solutions DC power systems may be used in close
proximity to other electronic equipment, provided installation is carried out according to
instructions in this guide. However, proper installation and compliance with EMC standards
does not guarantee that the DC power system will not respond to electromagnetic disturbances,
or will not cause interference to other equipment in a particular installation.
•
In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
•
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.

Inspecting the Equipment and Reporting Damage

Unpack the equipment and inspect it carefully for possible damage that may have occurred
while in transit.
Report any damage immediately, using a copy of the Equipment Incident Report on page 91.
Keep the original packaging and use it if any equipment needs to be returned for replacement or
repair.
12
Copyright © 2005-2007 Eaton Corporation. All Rights Reserved.
IPN 997-00012-54A July 2007