Repeat Copy - Kyocera KM-C2520 Advanced Operation Manual

Copy Functions

Repeat Copy

Set Repeat Copy to enable printing additional sets if required after copy completion. For confidential
documents, configure a passcode to use with Repeat Copy. If set, enter the correct passcode when
using Repeat Copy. Printing will not occur if the passcodes do not match.
NOTE: Repeat Copy jobs are erased when the main power is switched off.
Repeat Copy is not available when using document management function.
Repeat Copy is not available if the optional security kit has been installed.
It is also possible to disable Repeat Copy or configure Repeat Copy in default settings mode. For
further details, refer to Enabling Repeat Copy on page 7-11.
Preparing a Job for Repeat Copy
Configure Repeat Copy as shown below.
1 Press [Function] and then press [
2 Press [Repeat Copy].
3
Press [On].
For confidential jobs, press [# keys]
([#-Keys]) and input the passcode.
NOTE: Input the passcode 1 - 8 digits in length.
If the passcode is forgotten, Repeat Copy printing is not possible. Keep a record of the passcode as
needed.
4
Place the original and press the Start key. Copying begins and the job is stored as a Repeat Copy
job.
Repeat Copy Output
Press the Repeat Copy key to display the Repeat Copy list and review stored jobs. Jobs shown in
the list can be reprinted, viewed, or deleted.
Re-Printing Jobs
Follow the steps as below to reprint a Repeat Copy job.
1
Press the Repeat Copy key.
1-36
Down].
Ready to copy.
Repeat Copy
Password
Off
On
( Full-Color )
Shortcut
Modify copy allows sets to be save
# keys
to the HDD.
Using Repeat Copy function,
jobs can be recalled and output.
Individual passwords can be set.
Paper Size
11×8
100%
Back