Xerox Wide Format 6705 System Manual page 11

1 Getting to know this Service Manual
This manual is used as the standard service manual for the Xerox Wide Format 6705
System.
• Publication Comment Sheet
Enter any comments and/or corrections regarding the Xerox Wide Format 6705 System
service manual into the Publication Comment Sheet, and send it to the CS Department
TS Section.
2 How to use the Service Manual
This manual describes the standard service procedures for the Xerox Wide Format 6705
System. Refer to Chapter 1 Service Call Procedure for efficient and effective servicing
during maintenance calls.
2.1 Contents of Manual
• Hardware
This manual summarizes all technical information on the Xerox Wide Format 6705
System.
• Chapters
This manual is divided into 9 chapters as follows.
Chapter 1 Service Summary
This chapter describes the general work and servicing procedures for maintenance.
Chapter 2 Troubleshooting
This chapter describes the troubleshooting procedures other than image quality
troubleshooting.
Chapter 3 Image Quality Troubleshooting
This chapter describes the types of test patterns and the image quality
troubleshooting procedures.
Chapter 4 Disassembly/Assembly and Adjustment
This chapter describes the disassembly, assembly, and adjustment procedures for
the components.
Chapter 5 Parts List
This chapter contains the spare parts list.
Chapter 6 General
This chapter contains the following information.
6.1 Specifications
6.2 Tools/Service Consumables/Consumables/Modifications
6.3 Service Data
6.4 Service Mode
6.5 IIT PC-Diag
Getting to know this Service Manual
Introduction
6.6 Firmware Version Update
6.7 System Settings (Detailed Settings) List
Chapter 7 Wiring Data
This chapter contains the wiring information.
7.1 Plug/Jack Locations
7.2 Wire Network
7.3 BSD (Block Schematic Diagram)
Chapter 8 Accessories
This chapter contains the installation and removal procedures for the Accessories.
Chapter 9 Installation and Removal
This chapter describes the machine installation and removal procedures, as well as
the option installation procedures.
2.2 About the Revision Information
This manual will be revised as follows. Revisions must be incorporated correctly to keep the
manual up-to-date.
• Updating Procedure:
When the entire manual is revised, "1st Edition" on the front cover will be renamed to
1st Edition, 2nd Edition, 3rd Edition and so on.
Partial revisions will be marked starting with "Revision A", and follows the order of
Revision A, Revision B, Revision C and so on. Each revised page is marked with
"Revision A" or "Revision B" to clearly distinguish the revision status.
• Revision Sidebar
When any paragraph, table or figure has been added or amended, a revision sidebar
will be added to indicate where the revision was made.
If the same page is changed again due to a subsequent revision, revision sidebars
associated with the previous revision(s) will be deleted.
(E.g.)
xi