Configuration Switch - CPS COLOR COROB D200 Technical Manual

LED Status Description
OFF +24V not present
blinking signal present
DL1
OFF connector connected (RS485)
red connector connected (RS485)
DL2
blinking signal present
green connector connected (RS232)
DL3
DL4
blinking signal present
ON connector connected (USB)
TX1
blinking data are transmitted via USB
ON connector connected (USB)
RX1
blinking data are received via USB

3.2.3 Configuration switch

The S1 switch allows you to configure machine operation.
The switch configuration is read when the board is switched on; after any changes, you must shut down and
restart the machine to activate the new configuration.
SW1
The ON position is marked directly on the switches.
Any configurations not shown in the table are not permitted.
Version 1.0 - rev0 - May 2006
SW2 SW3 SW4 Description
normal operation
autotest (only factory-test use)
receive configuration
Relevant component / Notes
J26
J26
J27
J28
J28
3-7
ON
OFF