Disabling The Daylight Saving Time Adjustment; Clearing The Time Zone; Clearing Ntp Servers - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Chapter 35 Configuring NTP
Offset: 1440 minutes (1 day)
Recurring: no
Console> (enable)

Disabling the Daylight Saving Time Adjustment

To disable the daylight saving time clock adjustment, perform this task in privileged mode:
Task
Step 1
Disable the daylight saving time clock
adjustment.
Step 2
Verify the configuration.
This example shows how to disable the daylight saving time adjustment:
Console> (enable) set summertime disable Arizona
Summertime is disabled and set to 'Arizona'
Console> (enable)

Clearing the Time Zone

To clear the time zone settings and return the time zone to UTC, perform this task in privileged mode:
Task
Clear the time zone settings.
This example shows how to clear the time zone settings:
Console> (enable) clear timezone
Timezone name and offset cleared
Console> (enable)

Clearing NTP Servers

To remove an NTP server address from the NTP servers table on the switch, perform this task in
privileged mode:
Task
Step 1
Specify the NTP server to remove.
Step 2
Verify the NTP configuration.
This example shows how to remove an NTP server address from the NTP server table:
Console> (enable) clear ntp server 172.16.64.10
NTP server 172.16.64.10 removed.
Console> (enable)
78-12647-02
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Command
set summertime disable [zone_name]
show summertime
Command
clear timezone
Command
clear ntp server [ip_addr | all]
show ntp [noalias]
Configuring NTP
35-7