Accounting Example - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Accounting Example

Exec
Connect
Command
System
Console> (enable)
Accounting Example
Figure 27-5
accountable event on the switch, the switch gathers event information and forwards the information to
the server at the conclusion of the event. Accounting information is gathered at the conclusion of the
event. Accounting is suspended for unknown users and the system is updated periodically every
120 minutes.
Figure 27-5 TACACS+ Example Network Topology
TACACS+
172.20.52.10
Workstation A
In this example, TACACS+ accounting is enabled for connection, exec, system, and all command
accounting:
Console> (enable) set accounting connect enable stop-only tacacs+
Accounting set to enable for connect events in stop-only mode.
Console> (enable) set accounting exec enable stop-only tacacs+
Accounting set to enable for exec events in stop-only mode.
Console> (enable) set accounting commands enable all stop-only tacacs+
Accounting set to enable for commands-all events in stop-only mode.
Console> (enable) set accounting update periodic 120
Accounting updates will be periodic at 120 minute intervals.
Console> (enable) show accounting
Event
-----
exec:
connect:
system:
commands:
config:
all:
TACACS+ Suppress for no username: enabled
Update Frequency: periodic, Interval = 120
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
27-62
----- ----- ------
0 0
0 0
0 0
1 2
shows a simple network topology using TACACS+. When Workstation A initiates an
server
Switch
Method Mode
------- ----
tacacs+ stop-only
tacacs+ stop-only
tacacs+ stop-only
- -
tacacs+ stop-only
0
0
0
0
Console port
connection
Terminal
Chapter 27 Configuring Switch Access Using AAA
78-12647-02