Displaying The Sdm Templates - Cisco WS-C3560-48PS-S Software Configuration Manual

Displaying the SDM Templates

Displaying the SDM Templates
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | routing | vlan] privileged EXEC command to display the resource
numbers supported by the specified template.
This is an example of output from the show sdm prefer command, displaying the template in use.
Switch# show sdm prefer
The current template is "desktop default" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses:
number of igmp groups + multicast routes:
number of unicast routes:
number of policy based routing aces:
number of qos aces:
number of security aces:
This is an example of output from the show sdm prefer routing command entered on a switch:
Switch# show sdm prefer routing
"desktop routing" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses:
number of igmp groups + multicast routes:
number of unicast routes:
number of policy based routing aces:
number of qos aces:
number of security aces:
Catalyst 3560 Switch Software Configuration Guide
7-4
number of directly connected hosts:
number of indirect routes:
number of directly connected hosts:
number of indirect routes:
Chapter 7 Configuring SDM Templates
6K
1K
8K
6K
2K
0
512
1K
3K
1K
11K
3K
8K
512
512
1K
78-16156-01