Troubleshooting - Digital Control DIGITRAK FALCON F1 SINGLEBAND User Manual

Troubleshooting

MISSING ROLL AND PITCH
STEP 1 OF 3
Double-check that your transmitter is powered on.
a. Roll the transmitter 180°. They will fall asleep after 15 minutes of inactivity.
b. If you do not have data and are above ground, move the transmitter closer
to the locator. If the signal strength increases, try the next solution. If not,
insert fresh batteries. Lithium batteries will show 100% up until they're nearly
depleted.
STEP 2 OF 3
Re-Optimize your locator, pair your transmitter, and then calibrate.
If you have a new transmitter, or locator you must optimize, pair
your frequencies, and recalibrate.
For steps to re-optimize the locator, see "Advanced FO - Scan" in the Jobsite
Setup chapter.
For steps to pair your transmitter, see "Advanced FO - Pair" in the Jobsite
Setup chapter.
For steps to perform a 1 PT calibration, see "Calibrate" in the Jobsite Setup
Chapter.
STEP 3 OF 3
If you still don't have roll and pitch data, call DCI for further troubleshooting.
DIGITAL CONTROL, INC
DIGITRAK FALCON F1 SINGLEBAND USER MANUAL
DCI DigiGuide 05.18.2024
64