Download Print this page

Digital Control DIGITRAK FALCON F1 SINGLEBAND User Manual page 57

Dci digiguide

Advertisement

CHANGE V2 TX POWER MODE
STEP 1 OF 9
Things You Should Know
V2 Transmitters (V2 TX) have three power modes to balance signal strength
and battery life. See the V2 Transmitter Power Mode introduction for how the
power mode level affects depth readings and power level.
V2 transmitters are etched with a "V2" on the stainless battery compartment
(not on the label) and may have a multipower mode sticker around the IR
port.
The Falcon Plus locators ignore the V2 Power Mode selection
method described on the transmitter sticker and uses the
locator-specified power level.
After changing the power level, you must re-pair the transmitter
and then perform a 1 PT Calibration for each band changed. For
step-by-step instructions, see the articles "Advanced FO - Pair"
and "Calibrate Intro" in the Jobsite Setup chapter.
STEP 2 OF 9
From the Main menu, go to
Transmitter Selection.
DIGITAL CONTROL, INC
DIGITRAK FALCON F1 SINGLEBAND
USER MANUAL
DCI DigiGuide
05.18.2024
57

Advertisement

loading
Need help?

Need help?

Do you have a question about the DIGITRAK FALCON F1 SINGLEBAND and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Digitrak falcon f1