Digital Control DIGITRAK FALCON F1 SINGLEBAND User Manual page 29

Do not move the transmitter until you hear four beeps and a
checkmark appears.
STEP 7 OF 7
Confirm the pairing and power mode, and then click to continue to
Calibration.
If you are using a V1 transmitter, a warning reminds you that
only one power mode is available, and your selection will be
ignored.
CALIBRATE INTRO
Calibration is required anytime you perform a new frequency scan or change
any of the following:
Transmitter
Power mode of the transmitter
Locator
Drill head
Calibrate with the transmitter in the housing flat, on the ground, in a low-
noise, metal-free environment immediately after pairing.
To calibrate any other time,
from the Main menu select
Calibration, then 1 PT CAL
before continuing with the
following steps.
DIGITAL CONTROL, INC
DIGITRAK FALCON F1 SINGLEBAND USER MANUAL
DCI DigiGuide 05.18.2024
29