CALIBRATE
STEP 1 OF 8
Install the powered-on transmitter in the drill housing and install the cover.
STEP 2 OF 8
Using a tape measure, place the near edge of the locator parallel to and
exactly 10 ft (3 m) from the center of the transmitter.
For accurate calibration, always use the center of the
transmitter, not the drill housing.
STEP 3 OF 8
From the Main menu, select Calibration.
STEP 4 OF 8
Select 1PT CAL.
STEP 5 OF 8
Click the check mark to calibrate.
DIGITAL CONTROL, INC
DIGITRAK FALCON F1 SINGLEBAND
USER MANUAL
DCI DigiGuide
05.18.2024
30
Need help?
Do you have a question about the DIGITRAK FALCON F1 SINGLEBAND and is the answer not in the manual?