Omron ZG2 Series User Manual page 76

Note
Hint for adjusting the measurement region
Adjust the start and end points of the measurement region so that the desired measurement
position is enclosed.
Start position
Note
Custom settings available for height measurement
Setting value
REGION
MGNIFY
POS. (measurement
position)
MEAS (enabled only in
EXP menu)
ZG2 User's Manual
End position
Description
Fine-adjusts the measurement region when it is not ideally
set by AUTO.
Magnifies the profile display.
Selects whether to output the position of the measurement
value as the position in the height direction (Z coordinate)
or as the position in the horizontal direction (X coordinate).
Sets in more detail which height in the line beam that the
target is to be measured at.
Settings: AVE, PEAK, BTM, BEND
Setting Measurement Conditions
Reference
–
p.87
p.88
p.89
73