Omron ZG2 Series User Manual page 81

Note
Hint for adjusting the measurement region
Adjust the start and end points of the measurement region, and edge level so that the desired
measurement position is enclosed.
The edge level can be changed only in the EXP menu.
Start position
Note
Custom settings available for position and width measurement
Setting value
REGION
MGNIFY
EDGELV (enabled only
in EXP menu)
78
Setting Measurement Conditions
TRIMMING
↑↓
10.000 mm
←→
123 LINE SET
MEAS/WIDTH1
1ITEM 2CUSTOM
3SCALE
Edge level
End position
Description
Fine-adjusts the measurement region when it is not ideally
set by AUTO.
Magnifies the profile display.
Selects the edge level and edge search direction.
2
Enclose the desired
measurement area.
In the EXP menu, select [AUTO] and
set up this item.
Important
Adjust the region so that the center
line is aligned with the "edge to be
detected."
Center line
3
Check that the region is set
correctly.
When the region and edge level are
not ideally set to the desired
measurement position, adjust each
of region and edge level.
Reference
–
p.87
p.90
ZG2 User's Manual